Remounting the LED module for the daytime driving lights

Remove the LED module for the daytime driving lights 

• Loosen screws (1).
• Pull LED module (2) out of headlight.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock connector (1) at LED module (2) and disconnect it.
• Remove LED module (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

  Install the LED module for the daytime driving lights 

• Check the seal (1) on the LED module (2) for damage and replace where required.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connector (1) to LED module (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the LED module (2) in the headlight.
• Tighten the screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  LED module, daytime driving lights
  Screw	Tightening torque	1.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up Work 

• Install HEADLIGHT .
• Install front bumper PANEL .
• Install (partially removed) front section of front wheel arch COVER
• Install front ornamental GRILLE .
• ENCODE/PROGRAM control unit(s).
• Adjust HEADLIGHTS .