Installing intake filter housing

Prerequisite

Ignition is switched off.

Feed in the cable of the Lambda oxygen sensors through the opening on the intake filter housing (3).
Install intake silencer housing (3) and attach to the rubber mounts.
Connect the clean air pipe to the intake filter housing (3) and secure it with the clamps (2).

Tighten clamps (2).

TIGHTENING TORQUES SPECIFICATION

Clean air pipe to upper section of intake filter housing
cl.	Tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) of the hot film air mass meter.
The connectors (1) must engage audibly.
Attach the cable (2) of the Lambda oxygen sensors to the clamps.
Connect the connector (1) of Lambda oxygen sensors.
The connectors (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work