Install both fog light supports

Install the fog light support 

• Mount the fog light support (5).
• Install control unit (4).
• Tighten down screw (3).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Guide to the side on fog light holder
  	Tightening torque	3 Nm

• Attach the hose of the headlight cleaning system (2).
• Attach wiring harness (1).
• Engage the fog light support (1) at the latch mechanisms (arrows).
• Mount the expanding rivets (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the high-pressure nozzle of the headlight cleaning system 

• Check the retaining lugs (1) on the high-pressure nozzle (2).

  Retaining lugs must not be damaged or missing.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect high pressure line (1).
• Install high-pressure nozzle (3) to the front.
• Check high-pressure nozzle (3) for correct latch mechanism (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Carefully bend up guide (1) of the cover (2) in direction of arrow and clip into the high-pressure nozzle (3).
• Allow the high-pressure nozzle (3) of headlight cleaning system to slide back slowly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up Work 

• Install front BUMPER PANEL .
• Install (partially removed) front section of front wheel ARCH COVER
• Install FRONT GRILLE .