Notes on the installation of an exhaust turbocharger

Before installation: 

• Prior to the installation of an exhaust turbocharger, fill engine oil in the oil inlet in the exhaust turbocharger. At the same time, rotate the shaft on the exhaust turbocharger.
• Check the oil supply to the turbocharger and the oil return from the turbocharger for foreign bodies and oil sludging, clean if necessary.
• Ensure that no dirt and no foreign bodies enter the openings.
• Clean the charging air system.
  NOTE: Do not leave any oil residue or foreign bodies in the charge air duct.
• Replace gaskets, and ensure that the gaskets are installed correctly.
• Observe tightening torques.

After installation: 

• Start up engine and run it at idle speed for at least one minute to ensure that the exhaust turbocharger is receiving a proper oil supply. When the engine is cold and the ambient temperature is low, let the engine idle for approximately 2 minutes.
• Check 'tightness', i.e. seal integrity, of the engine oil pipes.
• Shut down the engine and check the oil level.

We can assume no liability for printing errors or inaccuracies in this document and reserve the right to introduce technical modifications at any time.