Installing the steering gear

NOTE: TECHNICAL INFORMATION
The screws for the steering gear are self-tapping. Therefore, no thread must be cut into the steering gear (or transmission).

Install the steering gear (2).
Position the screws (1) and only hand-tighten them.

Courtesy of BMW OF NORTH AMERICA, INC.
Install the anti-roll bar (3).
Position the screws (1) and (2) and only hand-tighten them.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
When assembling, it is essential to observe screwing sequences and tightening torques.
Non-compliance with the regulations can lead to damage.

Tighten the screws of the steering gear in the sequence (1) to (4).

TIGHTENING TORQUES SPECIFICATION

Steering gear to front axle support (all-wheel drive vehicles)
M12 Replace screws.	Joining torque	60 Nm
	Angle of rotation	90°

Fig 1: Steering Gear Screws Tightening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the screws (1) of the anti-roll bar on the front subframe.

TIGHTENING TORQUES SPECIFICATION

Holder, stabilizer mounting to front axle support
M12 Replace screw.	Joining torque	100 Nm
	Angle of rotation	45°

Courtesy of BMW OF NORTH AMERICA, INC.

Clip in the cable duct (2) on the front subframe.
Connect all connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.