Check the setting of the glass slide/tilt sunroof panel
- Check if the distance of the glass slide/tilt roof panel to the roof is the same at the front and rear.
- Slide the special tool 0 493 687 (00 9 340)
between the gasket (1) and the glass slide/tilt sunroof panel (2).
The resistance when shifting the special tool must be the same at the front and rear.
- Make sure that the glass slide/tilt roof panel is flush with the roof outer skin at the front or is up to a maximum of 2 mm lower.
- Make sure that the glass slide/tilt roof panel is flush with the roof outer skin at the rear or is up to a maximum of 2 mm higher.
- Measure the position of the glass slide/tilt roof panel (1) to roof (2) with special tool 0 495 259 (51 0 010).
