Installing the ignition coils

NOTE: RISK OF DAMAGE
Damage to the ignition coil.
The silicone hose of the ignition coil must not be contaminated by fuel as this can lead to failure of the ignition coil.

When working on the fuel system, cover the ignition coils with suitable materials and remove where required.
Do not oil or grease the silicone tube of the spark plug socket. Do not use any protection or maintenance products (e.g. silicone spray, rubber care products, rust remover, etc.).

NOTE: The description is for one component only. The procedure is identical for all further components.

Insert and install the ignition coil (3).

Tighten down screw (2).

TIGHTENING TORQUES SPECIFICATION

Ignition coil to cylinder head cover
Screw M6	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect and lock the connector (1).
The connector (1) must engage audibly.