Install Valvetronic servomotor, right (cylinder head removed)
NOTE:
TECHNICAL INFORMATION
The work must be performed with vehicle care to prevent component damage.
The work must be performed with vehicle care to prevent component damage.
- If necessary, lever the radial shaft seal (1) out of the cylinder head using a standard tool.
- Replace radial shaft seal (1) at front.
Parts: Radial shaft seal
- Grease the gearing on the worm drive in area (2) using lubricating grease.
Parts: lubricating grease
CONSUMABLE DESCRIPTION
| Lubricating grease Longtime PD-1 | 400 g, Cartridge | 83192160340 |
- Turn the Valvetronic servomotor (1) evenly with the shaft (2) across the gearing of the worm drive as far as it will go.
- Secure screws (3).
TIGHTENING TORQUES SPECIFICATION
| Valvetronic servomotor on cylinder head | |
| M6x16-8.8 | Tightening torque 9.6 Nm |
