Installing right intake plenum (cylinder head removed)
- Replace the seal (4).
Parts: Gasket
- Only during replacement of the intake plenum:
Loosen screws (1).
Unlock pressure sensor (2) on the retaining tab (3).
Remove pressure sensor (2).
Position pressure sensor (2).
Retaining tab (3) must audibly lock in.
Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Pressure sensor | |
| screw | Tightening torque 3 Nm |
- Position the left intake plenum.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Intake plenum | |
| M6 screw | Tightening torque 10 Nm |
- Tighten down screws (2).
TIGHTENING TORQUES SPECIFICATION
| Intake plenum | |
| M8 screw | Tightening torque 21.4 Nm |