Preparing the oil pressure check
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Pull the oil filter element (1) out of the oil filter housing (2) in the direction of the arrow.
- Observe the installation position (1) when inserting the oil filter element (2) into the special tool 2 209 377 (11 7 470) (3).
- Coat the sealing ring (2) with engine oil.
The oil filter element (2) must engage audibly.
- Release and remove the oil drain plug (1).TIGHTENING TORQUES SPECIFICATION
Special tool 117470 Special tool Tightening torque
10 Nm - Screw in the special tool 0 496 820 (11 7 430)
(1) in the special tool 2 209 377 (11 7 470)
and tighten.TIGHTENING TORQUES SPECIFICATION
Special tool 117430 Special tool Tightening torque
10 Nm - Screw the special tool 0 496 623 (11 4 310)
(2) into the special tool 0 496 820 (11 7 430)
(1) and tighten.TIGHTENING TORQUES SPECIFICATION
Special tool 114310 Special tool Tightening torque
15 Nm - Screw the Integrated Measurement Interface Box (IMIB) 100 bar sensor (3) into the special tool 0 496 623 (11 4 310) (2) and apply hand-tight.



