Install the front underbody protection or front thrust field
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
- Version A:
Insert the front underbody protection (1).
Tighten screws (arrows).
TIGHTENING TORQUES SPECIFICATIONUnderbody protection screw Tightening torque
3 Nm - Version B:
Position the front stiffening plate (1).
Replace screws (2).
Parts: Screws
Tighten down screws (2).
TIGHTENING TORQUES SPECIFICATIONThrust field to front axle support M8
Replace screws.Joining torque
25 Nm
Angle of rotation
70° - Tighten down screws (3).TIGHTENING TORQUES SPECIFICATION
Thrust field to holder M6 Tightening torque
8 Nm - Tighten down screws (4).
TIGHTENING TORQUES SPECIFICATION
| Underbody protection | |
| screw | Tightening torque 3 Nm |