Install the prop shaft on the transmission
NOTE:
TECHNICAL INFORMATION
For all-wheel drive vehicles from the 5 Series and 7 Series, the aluminum flexible discs have been eliminated and replaced with elastic flexible discs made of rubber as of production date 09/2015.
For all-wheel drive vehicles from the 5 Series and 7 Series, the aluminum flexible discs have been eliminated and replaced with elastic flexible discs made of rubber as of production date 09/2015.
- Check centering (1) for damage; replace if necessary.
- Check the centering (arrow) for damage and replace if necessary.
- Apply a thin coat of grease to the soft centering (1), if necessary.CONSUMABLE DESCRIPTION
Lubricating grease Olistamoly 2 LN 584 LO 100 g, Tube 83 19 0 447 919 - Do not
grease the hard centering (2).
- In order to avoid a humming of the drivetrain after reinstalling the prop shaft: It is essential to reassemble the three-hole flange (3) with the flexible disc (2) in the same position.
- Replace the screws and the self-locking nuts (arrows).
Parts: Screws, self-locking nuts
- Position the screws and the self-locking nuts (arrows).
- Hold down the bolts of the flexible disc on the nuts and tighten with the bolts.TIGHTENING TORQUES SPECIFICATION
Rear flexible disc to three-hole flange M12
Replace screws.
Joining torque and angle of rotation must be observed without fail.
Tightening via screw.Joining torque
55 Nm
Angle of rotation
90° - Secure the special tool angle of rotation 0 490 504 (00 9 120) with the special tool magnet 0 495 108 (00 9 130) on the vehicle underbody and continue to screw it in according to the angle of rotation.
