Fastening the charge air line
- Replace the sealing ring (1) on the throttle valve.
Parts: Sealing ring
- Check the sealing ring (1) on the charge air line for damage and replace if necessary.
Replacing the damaged seal
NOTE:
TECHNICAL INFORMATION
Use of sharp or pointy tools for installation or removal is prohibited.
Use of sharp or pointy tools for installation or removal is prohibited.
- Remove damaged seal.
- Clean the gasket groove (1) with a dry cloth.
The gasket groove (1) must be clean.
- Replace gasket.
Parts: Gasket
- Install the seal dry without lubricant or mounting agent.
NOTE:
TECHNICAL INFORMATION
Incorrect assembly is possible. Ensure correct installation position.
Incorrect assembly is possible. Ensure correct installation position.
- Thread in seal and install.
- Make sure that the seal is installed correctly in the gasket groove (1).
- Make sure that the sealing lip (2) is directed to the inside as shown.
- Position and fasten the charge air line (1).
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Charge air line to throttle body | ||
| M6 | Tightening torque | 8 Nm |
- Connect and lock the connector (1).
- Connect and lock the connector (2).
- Secure clamps (3).
