Install module carrier on the rear door (side window glass removed)

Check seal (1) of the module bracket (2) for damage.
If the seal (1) is damaged, the module carrier (2) must be replaced.

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in module bracket completely with the power window and close the snap fasteners (2).
Attach the wiring harness (1) and connect the connector.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Module bracket to door
Screw	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.