Adjust striker
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For more information see: 41 00... BODY GAP DIMENSIONS for body
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For more information see: 41 00... BODY GAP DIMENSIONS for body
NOTE:
Description is for left component only. Procedure on the right side is identical.
Prerequisite
Screws on the locking wedge have been loosened to such an extent that the locking wedge can be moved.
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For more information see: 41 00... BODY GAP DIMENSIONS for body
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For more information see: 41 00... BODY GAP DIMENSIONS for body
- Adjust the height of the locking wedge so that the door lock does not hit or drag.
- Move the striker sideways to set the gap between the door and the side panel at the rear.
- Tighten screws (1).
TIGHTENING TORQUES SPECIFICATION
| Lock striker | ||
| Screw | Tightening torque | 21 Nm |