Tire Pressure Monitor (TPM)

CAUTION: The system is inactive and cannot display a flat tire if a wheel has been mounted without TPM electronics or if TPM experiences temporary interference from other systems or devices that use the same radio frequency.

NOTE: The reset process finishes during driving, which can be interrupted at any time. When driving resumes, resetting is continued automatically.

Set the tire pressure of all wheels to specification.
On iDrive Control Center, select "SETTINGS", then "TPM".
Select "Reset TPM".
Start the engine, but do not begin to drive.
Select "RESET".
Drive vehicle. The tires are shown in gray and "Resetting TPM..." is displayed.
After a few minutes of driving, the set tire inflation pressures in the tires are applied as the set values to be monitored. Resetting process is completed automatically while driving. When resetting is completed, the tires in the display turn to green and "TPM Active" is displayed.

NOTE: If there is a problem resetting and applying the tire inflation pressures, all tires are shown in yellow on the Control Display, and a message is displayed.