Install windscreen

• Prepare the glue cartridge with the standard nozzle C.
• Apply bead joint in area (1)  .
• Apply adhesive bead within the mark on the windscreen.

Courtesy of BMW OF NORTH AMERICA, INC.

• Adhere to the geometry of the adhesive bead to make sure that one glue cartridge is sufficient for the complete windscreen.
• Carefully perform the following operations on the windscreen (1)  with suction lifter:
  • Running it in parallel to the A-pillar
  • Feed it in the area (A) on left and right below the side panel
  • Position at top
  • Align sides evenly
  • Press upwards until sealing rests evenly on roof
  • Press evenly all around
  • Fix with adhesive tape on the roof

Courtesy of BMW OF NORTH AMERICA, INC.

• Measure short length (A)  of the windscreen (1)  to the roof outer skin (2) with special tool 0 495 259 (51 0 010). 
• Adjust short length (A)  .

Gap dimension windscreen to roof outer skin
1 windscreen; 2 roof outer skin a  outer skin	Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the windscreen (1)  in such a way that the rubber frame (3)  lies even and parallel to the roof outer skin (2)  .
  NOTE: Perform the operations on the left and right side.
  • Mount the cover (1)  and attach it to the guide (3)  .
  • Engage the cover (1)  at the clip (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up Work 

• Secure front HEADLINING .
• Connect rain-light-solar-condensation sensor CONNECTOR
• Install the KAFAS camera with the integrated CONTROL UNIT .
• Install the interior MIRROR .
• Install the interior mirror COVERS .
• Install roof FUNCTION CENTER (FZD).
• Install left and right sun visor counter SUPPORTS .
• Install the left and right a-pillar TRIM PANEL .
• Install the left and right roof TRIM STRIP .
• Install cowl panel COVER .
• Install left and right WIPER ARM .
• Install the rear right engine compartment COVER .
• Install the rear left engine compartment COVER .
• Calibrate KAFAS CAMERA .