Installing the Car Pad Module (CPM)

• Position the Car Pad Module (CPM) (2) in the lid (3) and engage.

  Retaining lugs (1) must audibly snap into place.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the potential equalization (2) on the Car Pad Module (CPM) (5).
• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Potential equalization to Car Pad Module (CPM)
  M6x16 screw	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (3) and lock.
• Replace the clips with the cable tie (4).

  Part:  Clips with cable tie

• Mark the installation position of the adhesive pad (1) on the Car Pad Module (CPM) (2).
• Replace the adhesive pad (1).

  Parts:  Adhesive pad

• Fasten the adhesive pad (1) according to the mark made on the Car Pad Module (CPM) (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fold the lid (2) upwards with the Car Pad Module (/CPM).
• Tighten the screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Lid to thrust field
  M8x22 screw	Tightening torque	28 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Reconnect all battery GROUND LEADS .