Install rear upper seat belt
NOTE:
TECHNICAL INFORMATION
Component is encoded against incorrect assembly.
Component is encoded against incorrect assembly.
- Feed in and position the inertia reel (4).
- Replace the screw (2).
Parts: Screw
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Rear inertia reel to body | |
| Tightening torque | |
| M10 Replace screw. | 42 Nm |
- Replace the screw (3).
Parts: Screw
- Tighten the screws (3).
TIGHTENING TORQUES SPECIFICATION
| Additional connection of rear inertia reel to body | |
| Tightening torque | |
| M6 screw Replace screw | 4.5 Nm |
- Connect plug connection (1) and lock.
Follow-up Work
- Install the storage shelf TRIM PANEL .
- Install rear SEAT and rear seat backrest (not in case of SA465 through-loading system)
- Install the left and right backrest SIDE SECTION .
- Install both c-pillar TRIM PANELS .
- Connect all battery EARTH LEADS .
- Activate the 48 v ELECTRICAL SYSTEM .