Installing tie rod end

• Screw tie rod end onto the tie rod up to dimension (A), which was determined before removal.
  NOTE: If necessary, hold the track rod with an open-end spanner for counter support.
• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Tie rod end to tie rod
  M10	Tightening torque	32 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the tie rod end (2) on the swivel bearing.
• Replace nut (1).

  Parts:  Nut

• Tighten nut (1).
  NOTE: If necessary, counter-hold at the Torx socket.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Mount the WHEEL .
• Perform CHASSIS ALIGNMENT CHECK .