Install the rear active stabilizer
- Position the active stabilizer (1).
At the same time, guide the wiring harness to the outside through the body and rear axle support.
- Replace screws (2).
Parts: screw
- Tighten down screws (2).TIGHTENING TORQUES SPECIFICATION
Retainer, anti-roll bar to rear axle support M10
Replace screws.Tightening torque 56 Nm - Position the cable clip (2) and ground strap on the right-hand retainer.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Active stabilizer to right-hand retainer | ||
| M6 | Tightening torque | 8 Nm |
