Install and connect the wiring harness of the active stabilizer in the rear
- Secure the wiring harness on holders (4) and (5).
- Connect connectors (1) and lock.
- Connect the connector (2) and secure the cable on the holder (3).
- Fold the wheel arch trim panel (1) downwards.
- Tighten nuts (2).
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Wheel arch cover | |
| Screw | 3 Nm |
| Plastic nut | 2.6 Nm |
Follow-up work
- Secure the anti-roll bar, ANTI-ROLL BAR LINK .
- Install EXHAUST SYSTEM .
- Install the camber control arm COVER .
- Mount the rear right WHEEL .
- For replacement: PROGRAMING/CODING THE ACTIVE STABILIZER .