Installing the Car Pad Module (CPM) (engine oil service)

• Mark the installation position of the adhesive pad (1) on the Car Pad Module (CPM) (2).
• Release the adhesive pad (1).
• Replace the adhesive pad (1).

  Parts:  Adhesive pad

• Fasten the adhesive pad (1) according to the mark made on the Car Pad Module (CPM) (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove the special tool 2 413 317. 

  Do not leave the Car Pad Module (CPM) (1) hanging on the lines!

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the lid (2) with the Car Pad Module (CPM) on both guides on the thrust field and fold upwards.
• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Lid to thrust field
  M8x22 screw	Tightening torque	28 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Activate HIGH-VOLTAGE SYSTEM .
• Install flap in right luggage compartment TRIM PANEL .