Replace the right cylinder head cover

Loosen screw (1).
Remove the plate (2).
Guide out and remove the pressure sensor (3) at the cylinder head cover.

Courtesy of BMW OF NORTH AMERICA, INC.
Check the O-ring (1) for damage and replace it if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the pressure sensor (3) on cylinder head cover.
Position the plate (2).

Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

Pressure sensor on cylinder head cover
Screw TS6x12	Tightening torque:	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Sealing cap on cylinder head cover
M6x25 screw	Tightening torque:	10 Nm

Remount clamps (1) on the cylinder head cover (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (2).
Remove camshaft position sensors (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Check
Check O-rings (1) on the camshaft position sensors for damage.

Courtesy of BMW OF NORTH AMERICA, INC.

Result

» O-ring (1) damaged

Measure
Replace O-ring (1).
Parts: O-ring

Result

» O-ring (1) not damaged.

Measure

Continue the repair in the next step.
Coat O-ring of camshaft position sensor with engine oil.
Position camshaft position sensors (1).

Tighten down screws (2).

TIGHTENING TORQUES SPECIFICATION

Camshaft position sensor to cylinder head cover
Torx screw M6	Tightening torque:	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Oil separator to cylinder head cover
M6 screw	Tightening torque:	10 Nm

Courtesy of BMW OF NORTH AMERICA, INC.