Installing the LED module on the right decorative strip

NOTE: TECHNICAL INFORMATION 
The LED module must be re-addressed after replacement.
The address can only be configured with the diagnosis system using an applicable scan tool.
If a swap of LED modules was carried out as part of the troubleshooting, this swap should be reversed prior to auto-addressing.

NOTE: The description is for one component only. The procedure is identical for all further components.

• Clip LED module (2) into fiber-optic conductor.
• Clip LED module (2) into the latch mechanism (3).
• Clip the fibre-optic conductor into holder.
• Connect connector (1) to LED module (2).

Courtesy of BMW OF NORTH AMERICA, INC.