Install the outer door handle support
- Attach the Bowden cable nipple (3).
- Attach the Bowden cable (2).
- Twist and engage the tab (1).
- Attach the linkage (1) in the door lock (2).
- Guide in the door lock (3) together with the outer door handle support.
- Attach wiring harness.
- Connect the connector on the door lock (3).
- Tighten down screws (2).
TIGHTENING TORQUES SPECIFICATION
| Door lock to door | ||
| Screw | Tightening torque | 8.8 Nm |
- Tighten down screw (4).
TIGHTENING TORQUES SPECIFICATION
| Door lock to door | ||
| Screw | Tightening torque | 8.8 Nm |
- Clip in locking rod (1).
- Version with Automatic Soft Close system:
Fasten Automatic Soft Close drive (1) to the door.
Attach the connector of the Automatic Soft Close drive (1).
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Outside door handle support to door | ||
| Screw | Tightening torque | 2.6 Nm |
- Install the attachment hood (2).
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Attachment bell to outside door handle support | ||
| Screw | Tightening torque | 3 Nm |
Follow-up Work
- Install the front outside DOOR HANDLE .
- Install the front door MODULE CARRIER .
- Install the front door WEATHER STRIP .
- Install front door TRIM PANEL .
- Attach the door handle COVER .
- Fit exterior MIRROR .
- Install the mirror triangle COVER .
- ACTIVATE the 48 v electrical system.