Installing rear door trim panel

Attach the Bowden cable (1) in area (2) in the door trim panel.
Check clips (arrows) (3) for damage and, if necessary, replace them.

Courtesy of BMW OF NORTH AMERICA, INC.
Attach the Bowden cable (1) for the release lever on the door lock (3).
Attach the Bowden cable (1) for the release lever on the counter support (2).
Connect all the connectors and the cable clips of wiring harness (4) to the door trim panel.

Courtesy of BMW OF NORTH AMERICA, INC.
Attach door trim panel (1) at the top to the window cavity seal.
Clip the door trim panel (1) into the clips (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screws (1).

TIGHTENING TORQUES SPECIFICATION

Door trim panel
	Tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

If installed: Install the roller sunblind at the side window glass

Attach the roller sunblind (1) at the rear and engage it forward at the window guide.
Close side window.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up Work