Installing the LED module on the right decorative strip
NOTE:
TECHNICAL INFORMATION
The LED module must be re-addressed after replacement.
The address can only be configured with the diagnosis system using an appropriate scan tool
If a swap of LED modules was carried out as part of the troubleshooting, this swap should be reversed prior to auto-addressing.
The LED module must be re-addressed after replacement.
The address can only be configured with the diagnosis system using an appropriate scan tool
If a swap of LED modules was carried out as part of the troubleshooting, this swap should be reversed prior to auto-addressing.
NOTE:
The description is for one component only. The procedure is identical for all further components.
- Clip LED module (2) into fibre-optic conductor.
- Clip LED module (2) into the latch mechanism (3).
- Clip the fibre-optic conductor into holder.
- Connect connector (1) to LED module (2).
Follow-up Work
- Install the finisher on the right INSTRUMENT PANEL .
- Install the right instrument panel SIDE PANEL .