Installing the distributor block

NOTE: TECHNICAL INFORMATION
Seals must be replaced every time.
If the seal does not fit onto the radiator connecting flange, replace the radiator connecting flange.

Check the contact surface of the gasket on the radiator connection for contamination and clean if required.
Carefully insert the radiator connection (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the screws (1).

TIGHTENING TORQUES SPECIFICATION

Radiator connection
M6x35	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

Cooler connection on lower housing section
M6x16	Tightening torque	9 Nm

Courtesy of BMW OF NORTH AMERICA, INC.