Installing the lid of the high-voltage battery unit
NOTE:
TECHNICAL INFORMATION
The seal must be replaced every time the upper housing section is opened to guarantee the tightness of the high-voltage battery unit.
The seal must be replaced every time the upper housing section is opened to guarantee the tightness of the high-voltage battery unit.
- Replace gasket (1).
- Position lid (1) and screw down.TIGHTENING TORQUES SPECIFICATION
Lid for high-voltage battery unit M6x18 replace screws. Tightening torque 13 Nm Repair solution in the case of a faulty thread (M6)
NOTE:
TECHNICAL INFORMATION
If a bolt is not tightened to the specified torque or the thread is damaged, replace this thread.
A minimum of two threads must be undamaged.
If all threads are damaged, replace the housing.
If a bolt is not tightened to the specified torque or the thread is damaged, replace this thread.
A minimum of two threads must be undamaged.
If all threads are damaged, replace the housing.
- Drill out the damaged thread to 7.5 mm.
Exclusively drill out the threads when the upper housing section has been positioned to prevent shavings from penetrating the inside of the housing.
- Remove shavings using a vacuum cleaner.
- Screw in the thin-wall thread insert using the special tool 2 359 049 until slightly recessed by approximately 0.2 mm.
- Secure the upper housing section with the bolt.CONSUMABLE - THIN-WALL THREAD DESCRIPTION
Thin-wall threaded insert M6 41002288195
