Remove the coolant radiator with the air conditioning condenser
Prerequisite
- Ignition is switched off.
WARNING:
Hot fluids.
Risk of scalding!
Risk of scalding!
- Conduct all work in the vehicle wearing appropriate personal protective equipment only.
CAUTION:
Residual pressure in the heating and air conditioning system.
Injury hazard!
Injury hazard!
- Wear safety goggles and protective gloves when disconnecting the refrigerant line.
- Close the refrigerant lines with seal plugs.
CAUTION:
Materials harmful to health.
Danger to health through contact with health-endangering cloths!
Danger to health through contact with health-endangering cloths!
- Observe and uphold safety instructions on the containers and the notices on the safety data sheets of the manufacturers.
- Conduct all work in appropriate personal protective equipment only.
Preliminary work
- Refer to SUCTION THE AIR CONDITIONING .
- Refer to REMOVING THE COVER ON LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP .
- Refer to REMOVING LEFT INTAKE FILTER HOUSING WITH LEFT FRONT-END STRUT .
- Refer to REMOVING RIGHT INTAKE FILTER HOUSING WITH RIGHT FRONT-END STRUT .
- Refer to REMOVE FRONT CROSS CONNECTION .
- Refer to REMOVE THE REAR TOP CROSS CONNECTION .
- Refer to REMOVE FAN COWL .
- Refer to REMOVING THE FRONT RIGHT LOWER WHEEL ARCH COVER .
- Refer to REMOVING THE LEFT FRONT BOTTOM WHEEL ARCH COVER .
- Refer to REMOVE THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to REMOVING THE UNDERBODY PROTECTION OF THE STEERING GEAR AND THRUST FIELD RESPECTIVELY .
- Refer to DRAINING COOLANT .
Loosen electric coolant pump of return line from holder.
- Unlock retaining lug (1).
- Unscrew the electric coolant pump (2) counter clockwise and put it aside.
- Unlock and disconnect coolant lines (1).
- Place coolant lines to one side.
- Unlock the retaining clip (1).
- Detach the coolant line (2) and set aside.
- Unlock plug connection (1) and disconnect.
- Loosen screw (1).
- Loosen screw (1).
- Disengage the cover on cooling module on the bottom at the snap-in lugs (1).
Trim remains in the vehicle.
- Remove the coolant radiator with the air conditioning condenser (1) in an upward direction.
