Installing the Car Pad Module (CPM) (engine oil service)
- Mark the installation position of the adhesive pad (1) on the Car Pad Module (CPM) (2).
- Release the adhesive pad (1).
- Replace the adhesive pad (1).
Parts: Adhesive pad
- Fasten the adhesive pad (1) according to the mark made on the Car Pad Module (CPM) (2).
- Remove the special tool 2 413 317.
Do not leave the Car Pad Module (CPM) (1) hanging on the lines!
- Attach the lid (2) with the Car Pad Module (CPM) on both guides on the thrust field and fold upwards.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Lid to thrust field | ||
| M8x22 screw | Tightening torque | 28 Nm |
