Installing front brake pads
- If applicable, observe the identification of the removed brake pads.
If the brake pads are worn on one side, they must not be mixed up.
- Install the brake pads (1) into the brake caliper in the arrow direction.
- Remove the special tool (cable tie) 2 413 317.
- Install the brake caliper (3).
- Replace screws.
Parts: screw
- Tighten the screws (1), if applicable, hold against the hexagon head (2).
TIGHTENING TORQUES SPECIFICATION
| Guide bolt (brake caliper on brake anchor plate) | ||
|---|---|---|
| M8 Replace screws. | Tightening torque | 35 Nm |
Follow-up work
- Install front brake pad WEAR SENSOR (16 inch brake).
- Install the front left and right WHEELS .
- Commission/bed in (break-in) new BRAKE PADS and brake discs.
- Perform the CBS RESET .