Disconnect the bleeder unit for the brake fluid

• Switch off bleeder unit (1) and remove it from the brake fluid expansion tank.
• Check the brake fluid level and, if necessary, adjust it to the maximum mark.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check the seal (1) on the sealing cap for damage and replace if necessary.
• Mount the sealing cap on the brake fluid expansion tank.

Courtesy of BMW OF NORTH AMERICA, INC.

Install the cover of the engine compartment on the rear left 

• Install the cover (2).
• Lock the lock (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• If installed: check the GAS PRESSURE SPRING for bonnet (only for versions with active pedestrian protection (SA8TF)).
• Perform the CBS RESET .