Remove the prop shaft front at the front axle transmission
Preliminary work
- Deactivate the 48 v ELECTRICAL SYSTEM .
- Disconnect all battery GROUND LEADS .
- Remove rear UNDERBODY PROTECTION .
- Remove the UNDERBODY PLANKING of the transmission on the side
- Remove transmission CROSS-MEMBER .
- Remove the CONNECTING SUPPORT from the tunnel.
- If installed: remove the right and left TORSION STRUT where required.
- Remove complete EXHAUST SYSTEM .
- Remove the HEAT SHIELDS .
- Remove the RETAINING PLATES
- Partially loosen the PROP SHAFT
- Remove the TRANSFER BOX (ATC 13-1).
- Remove screws (arrows).
- Remove prop shaft.
