Installing forward/backseat adjustment drive unit
Prerequisite
The front seat is adjusted completely to the top.
- Insert the connecting shaft (1) into the transmission of the forward/back adjustment.
- Insert the drive (1) in the direction of the arrow and align it to the guide pins.
- Slice the drive (1) onto the short connecting shaft (2) without great effort and position it.
- Press the short connecting shaft slightly up from the bottom and align it to the drive (1).
- Insert the drive (1) completely.
- If necessary, use the long connecting shaft (3) to turn the drive (1) somewhat until it can be aligned and moved to the short connecting shaft (2).
- Insert the long connecting shaft (1) with the guide tube (2) into the transmission of the forward/back adjustment.
- Raise the drive (1) slightly.
Do not lift the drive (1) too far up; otherwise, the guide pins in the carrier plate may be damaged.
- Bend the guide tube (2) carefully and insert with the sleeve (3) into the drive (1).
- Clip the guide tube (1) and drive into the carrier plate (2).
- Insert holder (2).
- Make sure the retaining tabs (1) are correctly fitted in the holder (2).
- Connect connector (1).
- Clip cable clip (2) into the carrier plate.
Follow-up Work
- Install front seat rail COVER .
- Install the outer seat rail COVER .
- INITIALIZE the electrical seat adjustment drives.







