Install the positive battery cable from the remote positive terminal to the alternator
- Feed in and install positive battery cable.
- Connect plug connection (3) and lock.
- Position the positive battery cable on the alternator.
- Tighten nut (2).
TIGHTENING TORQUES SPECIFICATION
| Positive battery cable to alternator | ||
| M8 | Tightening torque | 19 Nm |
- Attach cover panel (1).
- Tighten down screw (4).
TIGHTENING TORQUES SPECIFICATION
| Wiring harness to cylinder head cover | ||
| M6x16 screw | Tightening torque | 10 Nm |
- Position ground cable (2).
- Tighten nut (3).
TIGHTENING TORQUES SPECIFICATION
| Ground cable to hold-down device | ||
| Nuts | Tightening torque | 5.5 Nm |
- Connect and lock the plug connection for the camshaft position sensors (1).
- Clip in the cable clip (1).
- Engage the positive battery cable on the holders (1).
- Feed in the positive battery cable (2) on the stud bolt on the remote positive terminal.
- Tighten nut (1).
TIGHTENING TORQUES SPECIFICATION
| Positive battery cable | ||
| Positive pole screw | Tightening torque | 15 Nm |
- Feed in the cover (1) in a downwards direction.
- Check the detents (2) are seated correctly.
Follow-up work
- Refer to CONNECTING THE LEFT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
- Refer to INSTALLING CLEAN AIR PIPE OF CYLINDER BANK 1 .
- Refer to CONNECTING THE RIGHT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
- Refer to INSTALLING THE RIGHT INTAKE FILTER HOUSING WITH THE RIGHT FRONT-END STRUT .
- Refer to INSTALLING CONTROL UNIT HOLDER FOR CYLINDERS 1 TO 4 .
- Refer to INSTALLING THE COVER OF THE RIGHT DME CONTROL UNIT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING NEGATIVE BATTERY CABLE .