Install the positive battery cable from the starter motor to the auxiliary terminal for jump starting
Positive battery cable from the starter motor to the remote positive terminal
Prerequisite
CAUTION:
Improper routing of the positive battery cable.
Risk of short circuits!
Risk of short circuits!
- Route the positive battery cable without abrasions and do not trap.
- Insert and install the positive battery cable (1).
- Secure the clamps (arrows).
- Insert and install the heat shield (2).
- Tighten nuts (1).
TIGHTENING TORQUES SPECIFICATION
| Heat shield to body | ||
|---|---|---|
| Nut | Tightening torque | 3 Nm |
- Insert and install the positive battery cable (1).
- Shift the positive battery cable (1) to the stop (2) on the starter motor.
- Tighten nut (3).
TIGHTENING TORQUES SPECIFICATION
| Battery positive lead to starter | ||
|---|---|---|
| M8 | Tightening torque | 13.5 Nm |
- Insert and install the positive battery cable (3).
- Secure clamps (2).
- Tighten nut (1).
TIGHTENING TORQUES SPECIFICATION
| Battery positive lead to battery positive terminal | ||
|---|---|---|
| M8 | Tightening torque | 19 Nm |
- Insert and install the cover (2) in the direction of the arrow.
- Ensure that the locks (1) engage audibly.
Follow-up work
- Refer to INSTALLING THE REAR THRUST FIELD .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALLING REAR UNDERBODY PROTECTION .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING NEGATIVE BATTERY CABLE .