Remove the wiring harness section for the ignition and injectors
NOTE:
DANGER
High-voltage system.
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
High-voltage system.
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
- All work on the high-voltage system may only be carried out by specially trained and technically experienced personnel.
- For additional information see:
- For additional information see:
WARNING:
Working on 12 V electrical system.
Risk of short circuits! Risk of fire!
Risk of short circuits! Risk of fire!
- Make sure that there is no charger connected to the jump start terminal in the engine compartment.
- Detach battery ground lead from battery.
- For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE SEAL FOR THE HOOD REAR .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING ACOUSTIC COVER AT REAR .
NOTE:
RISK OF DAMAGE
Damage to wires when disconnecting connectors and plug connections.
Sheared wires can cause a short circuit.
Damage to wires when disconnecting connectors and plug connections.
Sheared wires can cause a short circuit.
- Do not pull on wires when disconnecting connectors and plug connections.
- Unlock and loosen clamp (1).
- Guide and remove cover (2) in arrow direction.
- Unlock and loosen all connectors (1) in the direction of the arrow.
- Unlock and detach the connector (arrows).
- Unfasten nut (1).
- Feed out ground cable (2) and set it aside.
- Lift cable duct (3).
- Unlock and detach connector (1) from injectors.
- Unlock lock (1) arrow direction from the top.
- Press lock (1) together and release.
- Detach the connector (2) from the injectors.
- Loosen clamp (1).
- Unlock and loosen holder (2).
- Unlock and loosen holder (3).
- Guide the wiring harness section for the ignition and the injectors (4) out and remove them.
