Install the wiring harness section for the ignition and injectors
Wiring harness for the injectors and ignition coils
NOTE:
RISK OF DAMAGE
Improper routing of cables and wiring harnesses.
Trapped, crushed or damaged cables may cause short circuits and malfunctions.
Improper routing of cables and wiring harnesses.
Trapped, crushed or damaged cables may cause short circuits and malfunctions.
- Route all cables without abrasions, do not trap and crush.
- Guide in and install the wiring harness (1) for the injectors and ignition coils.
- Connect connectors (1) and lock.
The connectors (1) must engage audibly.
- Guide in the wiring harness section (2) and install.
- Ensure that the lock (1) engages audibly.
- Insert and install the wiring harness (3).
- Connect the holder (2) and lock.
The holder (2) must engage audibly.
- Secure clamps (1).
- Guide in the wiring harness section (2) and install.
- Tighten nuts (1).TIGHTENING TORQUES SPECIFICATION
Ground cable to rail M6 Tightening torque 5 Nm - Connect the connector (1) to the injectors.
The connector must engage audibly.
- Lock the locking mechanism in arrow direction.
- Connect connectors (1) and lock.
The connectors (1) must engage audibly.
- Connect connectors (1) and lock.
The correctors (1) must engage audibly.
Follow-up work
- Refer to INSTALLING COVER FOR THE DME CONTROL UNIT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING NEGATIVE BATTERY CABLE .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .