Installing the control unit holder

• Feed in the control unit bracket (1) and position it.
• Secure the clamps (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the bottom control unit holder (1) is inserted correctly into the fixture (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the control unit holder (2) and install.
• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Control unit bracket at the shock tower
  Hexagon screw	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten the holder (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and install the holder (2).
• Make sure that the lock (1) engages audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the clamp (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the clamp (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the cable clip (1) with the control unit holder (2) and tack it.

  Lock (arrow) must audibly engage.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure clamps (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide in the wiring harness section (2) and Install.
• Ensure that the lock (2) engages audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to PARTIALLY INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
• Refer to INSTALLING THE DME CONTROL UNIT .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to CONNECTING NEGATIVE BATTERY CABLE .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
• Refer to IF THE DME CONTROL UNIT IS REPLACED: PROGRAM/CODE DME CONTROL UNIT .