Installing gasoline particulate filter
- Replace gasoline particulate filter (1).
Parts : Gasoline particulate filter
- Feed the gasoline particulate filter (1) in with the assistance of a second person and install it.
- Version 1 (Ribbon clamp)
Replace the (1) ribbon clamp.
Parts : Ribbon cable clamp
Tighten the ribbon clamp (1).
TIGHTENING TORQUES SPECIFICATION
| Exhaust system to catalytic converter | ||
| Ribbon clamp nut M8 Replace the ribbon clamp. |
Tightening torque | 26 Nm |
| Ribbon clamp nut M10 Replace the ribbon clamp. |
Tightening torque | 55 Nm |
- Version 2 (V-band clamp)
- Replace V-band clamp.
Parts : V-band clamp
- Unscrew the nut (1) and remove the sealing ring (2).
- Bend all sheet metal tabs over with a suitable tool, except those in the marked areas.
- Mount the V-clip (1) on the sealing ring (2).
- Make sure that the V-clip (1) is positioned correctly on the sealing ring (2).
- Make sure that, after mounting, the V-ribbon clip is on the sheet metal tabs (marks).
- Connect the exhaust system (1) with the catalytic converter (2) (arrow) and position correctly.
- Make sure that V-clip (1) is fitted correctly.
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| V-ribbon clip to catalytic converter | ||
| V-ribbon clip Replace V-ribbon clip. |
Tightening torque | 25 Nm |
- Replace nut (1).
Parts : Nut
- Tighten nut (1).
TIGHTENING TORQUES SPECIFICATION
| Front pipe/front silencer/gasoline particulate filter to the transmission holder | ||
| M8 Replace nut. |
Tightening torque | 19 Nm |
- Connect the gasoline particulate filter (3) with a gripper clamp (2) to the rear silencer (1).
- Center the gripper clamp (2) and tighten the nuts (4).
TIGHTENING TORQUES SPECIFICATION
| Clamp with partial replacement of exhaust system | ||
| Clamp | Tightening torque | 45 Nm |
Follow-up works