Installing the right-hand rail pressure sensor

Prerequisite 

Rail removed.

• Screw in and tighten the rail pressure sensor (1) into the rail.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALL THE RIGHT HIGH-PRESSURE RAIL .
• Refer to INSTALLING THE SOUND INSULATION ON THE RIGHT-HAND CYLINDER HEAD COVER .
• Refer to SECURE THE WIRING HARNESS ON THE CYLINDER HEAD COVER ON THE RIGHT .
• Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS CONTROL UNIT ON THE RIGHT .
• Refer to INSTALL THE INTEGRATED POWER SUPPLY MODULE (PDM) .
• Refer to INSTALLING THE DME CONTROL UNIT FOR CYLINDERS 1 TO 4 .
• Refer to CHECK THE COOLANT LEVEL IN THE LOW-TEMPERATURE COOLANT CIRCUIT AND TOP UP, IF NEEDED .
• Refer to INSTALL REAR UNDERBODY PROTECTION .
• Refer to INSTALL RIGHT CLEAN AIR PIPE .
• Refer to CONNECTING THE RIGHT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER
• Refer to INSTALLING THE RIGHT UNFILTERED-AIR DUCT .
• Refer to INSTALLING ALL IGNITION COILS ON THE RIGHT .
• Refer to INSTALLING INTAKE FILTER HOUSING .
• Refer to INSTALL ACOUSTIC COVER .
• Refer to INSTALL THE REAR TOP CROSS CONNECTION .
• Refer to INSTALL FRONT CROSS CONNECTION .
• Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
• Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .