Installing the intake pipe
- Feed in the intake pipe (2) and position.
- Lock the retaining clip (1).
The retaining clip (1) must engage audibly.
- Position the wiring harness (2).
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Wiring harness on the cylinder head cover M6x16 screw Tightening torque 10 Nm Nut M6 Tightening torque 10 Nm - Guide in and install cover (3).
- Clip in the intake pipe (2) in the area (3) of the holder.
- Lock the retaining clip (1).
The retaining clip (1) must engage audibly.
Follow-up work
- Refer to INSTALLING CONTROL UNIT HOLDER FOR CYLINDERS 1 TO 4 .
- Refer to INSTALLING THE COVER OF THE RIGHT DME CONTROL UNIT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING NEGATIVE BATTERY CABLE .


