Installing the transmission oil pan (all-wheel drive vehicle) (GA8HP75Z, GA8HP76Z, GA8HP95Z)
NOTE:
TECHNICAL INFORMATION
The transmission oil pan must be replaced each time it is released.
The transmission oil pan must be replaced each time it is released.
- Clean the contact surface of the transmission oil pan on the transmission.
- Replace screws (1) to (13).
Parts: screw
- Position the transmission oil pan.
- Hand-tighten the bolts.
- Tighten screws in the order (1) to (13).TIGHTENING TORQUES SPECIFICATION
Transmission oil pan M6
Replace screws.Tightening torque 10 Nm - If necessary, tighten the oil drain plug (1).
TIGHTENING TORQUES SPECIFICATION
| Oil drain plug | ||
|---|---|---|
| M18 Replace screw. |
Tightening torque | 8 Nm |
Follow-up work
- Check/top up the automatic transmission OIL LEVEL .
- Install rear UNDERBODY PROTECTION .
- Install the transmission side UNDERBODY PLANKING .