Removing the mechatronics

Preliminary work

Deactivate the 48 v ELECTRICAL SYSTEM .
Disconnect all battery GROUND LEADS .
Remove the transmission side UNDERBODY PLANKING
Remove rear UNDERBODY PROTECTION .
Remove the transmission OIL PAN (all-wheel drive vehicle) (GA8HP75Z, GA8HP76Z, GA8HP95Z).
Remove the oil volume RESERVOIR (GA8HP50Z, GA8HP51Z, GA8HP75Z, GA8HP76Z, GA8HP95Z).

CAUTION: Materials harmful to health.
Contact with fluids harmful to health!

Note and follow safety instructions on containers.
Conduct all work in appropriate personal protective equipment only.

Pull the selector shaft tappet (1) downward with the special tool 2 355 850 (3) in the direction of the arrow.
Install the special tool 2 355 850 (2) between the selector shaft tappet (1) and transmission housing in arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Turn connector (1) in arrow direction and detach.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert special tool 0 494 213 (24 2 390) in sealing sleeve (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Release the screw (1) and unlock the sealing sleeve with the slide (2) in arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Observe the installation position of the sealing sleeve (1).
The sealing sleeve (1) must be installed in the same position during installation.
Pull out the sealing sleeve (1) in direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.
Release the screws from the mechatronics in the marked area (1).
Install the special tool 0 496 715 (24 1 430) in the marked area (1).
Tighten the wing nuts (1).
Loosen screws (2).
NOTE: TECHNICAL INFORMATION
The tappet on the output RPM sensor may break off during removal or installation.

NOTE: TECHNICAL INFORMATION
Note the original installation position of the output RPM sensor.
Observe the correct installation position when installing the output RPM sensor.

Courtesy of BMW OF NORTH AMERICA, INC.
Carefully pull the output RPM sensor (3) out of the housing and insert it in the recess on the module.
Loosen screws (1).
Remove the wing nuts of special tool 0 496 715 (24 1 430) .
NOTE: TECHNICAL INFORMATION
Carefully remove mechatronics.
Remove mechatronics.

Courtesy of BMW OF NORTH AMERICA, INC.
Remove pressure pipe (1).

Courtesy of BMW OF NORTH AMERICA, INC.