Instructions for opening and part exchange in refrigerant circuit (530i 2017-2022, 530i xDrive 2017-2022, 530e PHEV 2018-2022, 530e xDrive PHEV 2018-2022, 540i 2017-2022, 540i xDrive 2017-2022, M550i xDrive 2018-2022)

Required special tools:

00 9 030
32 1 270

WARNING:

Avoid contact with refrigerant and refrigerant oil
Follow safety informations for HANDLING REFRIGERANT .
Follow safety information for HANDLING REFRIGERANT OIL .

Attention!

Always use new O-rings each time A/C connections are opened (refer to the applicable BMW Electronic Parts Catalogue) They must not be coated.
Use special tool 00 9 030 to install sealing rings without damaging them.
Open the refrigerant circuit for as short of a period as possible.
Close all components and lines in the refrigerant circuit and return parts immediately following the removals at openings with special tool 32 1 270 to prevent penetration of moisture or foreign objects.
If the refrigerant circuit was closed at the openings with special tool 32 1 270 but it remains open for more than 24 h, the dryer insert for the air conditioning must be replaced.

Part replacement as preliminary work fur further repair work and part replacement based on gradual leakage.
(minor leak, e.g. hairline crack)

Procedure:
- Draw off heating and air conditioning system, then determine drawn-off amount of refrigerant oil
- Carry out part replacement
- Replace removed refrigerant oil and additionally top up with new refrigerant oil according to components replaced:
  - Compressor: refer to NOTES on compressor replacement
  - Evaporator: 10 mL
  - Capacitor: 20 mL
  - Desiccant insert/dryer flask : 20 mL
  - Each replaced refrigerant line: 10 mL
  - Condenser with integrated dryer flask: 40 mL
  - Safety pressure switch and gasket: no additional refrigerant oil
  - Only 101: Radiator, high-voltage battery unit: 20 mL
- Evacuate and fill air conditioning system
II. Part replacement due to sudden leakage
(major leak, e.g. line disconnection due to accident)

Procedure:
- Draw off heating and air conditioning system, then determine drawn-off amount of refrigerant oil
- Carry out part replacement
- Replace removed refrigerant oil and additionally top up with new refrigerant oil according to components replaced:
  - Compressor: refer to NOTES on compressor replacement
  - Evaporator: 35 mL
  - Capacitor: 35 mL
  - Desiccant insert/dryer flask: 55 mL
  - Each replaced refrigerant line: 35 mL
  - Condenser with integrated dryer flask: 55 mL
  - Safety pressure switch and gasket: no additional refrigerant oil
  - Only 101: Radiator, high-voltage battery unit: 35 mL
- EVACUATE and fill A/C system