Install the active stabilizer in front
- Position active anti-roll bar (3) on front axle support.
- Replace screws (1) and (2).
Parts: screw
- Tighten down screws (1) and (2).
The bolts have different lengths. Pay attention to installation position!
Screws (1) = M12x89
Screws (2) = M12x50
TIGHTENING TORQUES SPECIFICATIONAnti-roll bar to front axle support M12
Replace screws.Joining torque 100 Nm Angle of rotation 45° - Position wiring harness on holder.
- Tighten the bolt (1) with the ground strap on the holder and wiring harness.TIGHTENING TORQUES SPECIFICATION
Front active stabilizer cable with ground strap to holder Tightening torque 8 Nm - Position the holder of the connector for the active stabilizer on the front axle support.
- Tighten down screw (1).TIGHTENING TORQUES SPECIFICATION
Active stabilizer connector bracket to front axle support Tightening torque 8 Nm - Connect plug connections (1) and (2).
