Installing the front rubber mount for the rear axle support
NOTE:
Description is for left component only. Procedure on the right side is identical.
Preparing the rubber mount for installation
- Clamp special tool 2 455 956 in vice.
- Observe the arrow position (1)
on the lower side of the special tool 2 455 956
.
- Position the rubber mount (2)
correctly:
The arrow (1) must point in the same direction as the arrow on the special tool 2 455 956 .
- Tighten the rubber mount (1) on the special tool 2 455 956 with the special tool 0 492 412 (33 4 155) up to the limit position.
Align the front rubber mount on the rear axle support
- Align front rubber mount (1)
in direction of travel by means of the arrow on special tool 2 455 956
or on rubber mount (2)
.
(F) = direction of travel
(View of the rear axle support from the top)
- Pull the rubber mount (1) with the special tools 2 455 956, 0 492 397 (33 4 140), 2 208 575, 2 155 744 and 2 208 574 into the rear axle support .
- Remove the special tools.
