Installing the anti-roll bar

Courtesy of BMW OF NORTH AMERICA, INC.

• It is paramount to observe the installation position when installing the anti-roll bar!

  Graphic (1) shows the correct mounting orientation.

  Graphic (2) shows the incorrect installation position.

  NOTE: TECHNICAL INFORMATION 
  Do not mix up the left and right.
• It is paramount to observe the installation position when installing the retaining brackets (1)!

  (L) = left retaining bracket

  (R) = right retaining bracket

  (F) = direction of travel

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the anti-roll bar (2) from the side and position on the rear axle support.
• Position the retaining bracket (3).
• Replace screws (1).

  Parts:  Bolts

• Tighten the screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Retaining bracket, anti-roll bar to rear axle support
  M10 Replace screws.	Tightening torque	56 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up Work 

• Secure the left and right anti-roll bar, anti-roll BAR LINK .
• Install the camber control arm COVER .
• Install the rear left WHEEL .